Seller notes

Prevent Hyperblinking. When you replace incandescent turn signal bulbs with LEDs in most vehicles, the vehicle will start hyperblinking. This is because the LED uses much less power, and the vehicle thinks the bulb is out. You can easily fix this problem by installing resistors. Installation. Each resistor has 6 inch leads for easier installation, and has a rating of 50 watts, 6ohm. This is usually enough to compensate for one bulb. If you are installing four LED turn signals (front and rear), w...

Contact Us regarding this vehicle

Contact Seller on eBay

You will be redirected to eBay

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission.