Seller notes

I had these engine plates made years ago. I used two sets and have three left. They are for installing a pre unit Triumph engine and Triumph swingarm type gearbox into a Norton slimline featherbed frame. They’re made for an engine without a generator but can be trimmed to use with a generator. You may need to cut a hole for your clutch cable depending on the configuration you’re planning to use. They are made of ¼” thick 6061-T6 aluminum....

Contact Us regarding this vehicle

Contact Seller on eBay

You will be redirected to eBay

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission.